Air-Topper Tech Page

FLATED AIR-TOPPER™ TECHNOLGY

The Flated Air-Topper starts with the most advanced inflatable materials offered today. The Drop Stitch material allows us to make ridgid structures that can be inflated with rock hard ridgidity when installed and then deflated and rolled into a convenient backpack for compact storage.


Drop stitch material is at the heart of all FLATED inflatable products. The surfaces of the fabric is connected to each other through vertical polyester pile fibers. Using tens of thousands of tough polyester threads, drop stitch technology lets us build inflatables with flat surfaces that can be inflated to rock-hard rigidity. You get hard-shell performance along with the easy transportation and storage of all of our inflatables. 

The process starts by joining two pieces of polyester woven support fabric with thousands of fine polyester lengths. This base material is made in strips from five to ten feet in width.  Up to 400 needle heads may be used in the setup. Each needle sews a continuous, evenly spaced thread, back and forth between the two pieces of woven fabric, locking them together into an incredibly strong unit. These drop-stitch sewing machines are marvels of complexity. When a change is made in the spacing distance between the two pieces of woven fabric, it can take over 20 days to remove and replace the required needles. The Polyester threads are woven so thin that when it is deflated, the two layers can collapse together almost completely flat, allowing our products to be rolled up and stored in a much smaller space. Drop stitch comes in many thicknesses but the most common for for FLATED products are 2- 4- or 6- inch drop stitch.